UnMinted Metal Stamping Quick-Change Jig | Arbor buying Press 1" Ram Edition

Updated Jig Design - Now printed in tough solid nylon.

Installing the Arbor Press Quick Jig:
The Arbor Press Quick-Jig is designed to work with 1 Ton Arbor Presses which have up to a 1” unmodified ram, and while stamping on a flat / level stamping surface.

Start by lowering the ram and position the metal collar around the ram. Position the Arbor Press Quick-Jig onto the ram - you can rest the ram down onto the jig using the upper magnet in the jig to help hold it in place. Position the metal collar so that the set screw is facing a flat metal side of the ram (not the plastic of the jig), and lower the collar down over the round portion of the jig - this should be a nice, snug fit. With the ram still resting down against the jig and sitting on your flat stamping surface, use the provided 3/16” hex key to tighten the set screw against the side of the ram. You want it snug, just not so tight as to crush the jig.

Using the Arbor Press Quick-Jig:
Once your Quick-Jig is installed securely onto the ram, then you're ready for stamping!

Snap your metal stamp of choice into the corner pocket against the magnets and position your work piece under the stamp.

- Keeps buying your metal stamps straight for consistent impressions.
- Allows for easy positioning OVER your work.
- Allows for quick changes between a wide variety of metal stamps of varying shapes and sizes.

The UnMinted Metal Stamping Quick-Change Jigs work with a wide variety of metal stamps in varying shapes and sizes - regardless of brand.

The Metal Stamping Quick-Change Jig.