Bubinga prefinished wood veneer 10" x 14" buying on MDF panel board 5/8'' thick "AA"

$67.81
#SN.015121
Bubinga prefinished wood veneer 10" x 14" buying on MDF panel board 5/8'' thick "AA",

Bubinga prefinished wood veneer 10" x 14" on MDF panel board 5/8 thick.

Black/White
  • Eclipse/Grove
  • Chalk/Grove
  • Black/White
  • Magnet Fossil
12
  • 8
  • 8.5
  • 9
  • 9.5
  • 10
  • 10.5
  • 11
  • 11.5
  • 12
  • 12.5
  • 13
Add to cart
Product code: Bubinga prefinished wood veneer 10" x 14" buying on MDF panel board 5/8'' thick "AA"

Bubinga prefinished wood veneer 10" x 14" on MDF panel board 5/8 thick "AA"quality grade veneer. Clear semi gloss finish. Back of the MDF (medium density fiberboard) has nothing on it. Finish looks good, but you may want to touch it up some. Finish has some natual wave to it that follows grain. Color leans a little more maroonish and maybe less red than some photos show. Pretty piece of wood.

Trust the experience, knowlwedge and reputation that we have offered the wood industry since 1995.

Visit My Store: JSO Wood Products

Other sizes and backed veneer may be available.

About pictures: Most pictures have been temporarily wet on the lower portion of the veneer to show what the grain may look like when finish is added. Color adjustments have been made to show buying the color as best as is possible. It is impossible to get photos exactly correct in color, but we have made an effort to do so.

Backed products come with complete application instructions that are simple and clear. For raw veneer or un-backed products, we suggest using the Internet to see what advice is available as opinions vary on the best way to handle that product. Below is general information for most of our products. Make sure you check the listing to see which applies to the above product in particular.

Thickness: (will not always be exactly correct, but relatively close)

Paper-backed veneers = 1/40

Wood-backed veneers = 1/25

Raw plain veneer with no backing = 1/32-1/42

How to cut: generally cut with a razor/box knife or similar tools and some type of straight edge.

How to apply: Paper-backed and wood-backed veneers are generally applied with contact cement. Raw plain veneer is applied with white or yellow wood glue and must have pressure applied while drying.

How to finish: most any conventional finishing products can be used with veneer that is applied correctly.

Disclaimer: Sometimes veneers have minor splits or tears in them. These are usually taped or repaired in some manner and shouldnt impact overall quality or satisfaction. There may also be some minor wood filler used to fill cracks and other crevices that may exist. Wood products are rarely perfect and some consideration of that may be needed occasionally since this is a natural product and is rarely ever perfect.

Some sanding is usually required before finishing to prepare the surface for a finish and occasionally to remove veneer tape, splice glue, or some other imperfection.


SKU:mx1_121443647373*

.
715 review

4.78 stars based on 715 reviews